About EDR3RXD1 Compatible Replacement Filter

EDR3RXD1 Compatible water filters perfect for Kenmore and Whirlpool refrigerators. We use activated carbon Block to remove 99% of impurities.  No worries about the EDR3RXD1 Compatible water filters with the leakage problem. WFS EDR3RXD1 water filter is NSF 42,53, 401 certified. All water filters under strict quality tests before going to the market.  No tool Required installation. Just aim at the direction. Installation of Everydrop water filter 3 is done in about 5 minutes.  We have very professional customer service and you can ask for help if you have any problems with our products.

Email address: contact@waterfilter-system.com.

How to Install Whirlpool Refrigerator Water Filter EDR3RXD1?

This is the installation of the EDR3RXD1 compatible water filter. To maximize contaminant reduction including pharmaceuticals, replace your filter every six months.

Step one

Be sure you have the correct filter if you need help to decide that the EDR3RXD1 water filter is right for your refrigerator, please feel free to contact us. 

Step two

Remove your new filter from its packaging, lift the blue cap from the top of the

filter. Be sure the black rings are still in place.

Step three

Locate your filter in your refrigerator, for Whirlpool water filter EDR3RXD1, you'll find it on the left side of the base grille. Remove the filter by pressing and holding down the eject button while pulling it straight out on the filter cap. Remove the filter cartridge
cap by turning it counterclockwise until it stops and the ridge is aligned.

Step Four

Then pull the cap straight off the end of the cartridge. Set aside the filter cap and do not discard it. Note that excess water may spill from the old filter so have a towel handy.

Step Five

Time to install your new EDR3RXD1 compatible water filter. Place the filter cartridge cap on the new filter by aligning the ridge on the cap with the arrow on the filter. Turn the cap clockwise until it stops and snaps into place.

Hold the assembled cap and filter unit by the lip on the cap. So that the filter cartridge arrow is facing up.

Align the filter and cap unit with the opening in the grille base and push the new filter into the hole. Once the filter is completely inserted the eject button will pop back out now.

Now, flush four gallons through your refrigerator water dispenser before drinking. This removes any air and ensures the fast flow performance of the edr3rxd1 water filter for cleaner tasting water.






Subcribe to Get the Biggest Discount

×
Welcome Newcomer